Send a question to technical support
		Mailbox Management

Dial-Up Networking Settings For Windows 2000 To Work With PeterStar Node

After your modem has been installed and identified by Windows, it is necessary to check its settings: connections are advisable to be prohibited without error control. For that press the button Start,

then Settings, and select Control Panel.

Find there the icon Phone and Modem Options. Then a window appears, in which you should open the bookmark Modems, select with the cursor the modem installed, and press Properties.

Select the bookmark Advanced and press the button Change Default Preferences. Put Disabled in the column Compression.

If the Windows system failed to identify your modem’s type, please consult with your equipment suppler.

2. Installation of Required Components

Press the button Start, then Settings, and select Control Panel. Find there the icon Add/Remove Programs,

open the tab Add/Remove Windows Components, select Networking Services,

press the button Details and tick off the item Simple TCP/IP Services. Press OK and the button Next, then Finish.

3. Establishing Connection with PeterStar

Press the button Start, then Settings, and select Control Panel. Find there the icon Network and Dial-up Connections. Double click on the icon Make New Connection. Press the button Next,

select Dial-up to private network, and press the button Next.

Specify the number of modem pool: 320-3370, remove the flag Use dialing rules, and press the button Next.

Enter the name of this connection (for instance PeterStar). Tick off Add a shortcut to my desktop if you want this connection to present on your desktop.

After clicking Finish the created connection opens, in which you need to click Properties.

After the bookmark General opens, click Configure and remove the flag Enable modem compression.

Then press the button OK and go to the bookmark Networking, in which you need to click Settings and remove the flags Enable software compression and Negotiate multi-link for single link connections. Press the button OK once and go to the TCP/IP protocol settings.

For that in the bookmark Networking, the items Components checked are used by this connection, Client for Microsoft Networks and Internet Protocol (TCP/IP)must be specified and ticked off.

If the required components are absent, they must be added as follows:

• Client for Microsoft Networks (click Install, then Client, and select Client for Microsoft Networks);
• Internet Protocol (TCP/IP) (click Install, then Protocol, and select Internet Protocol (TCP/IP)).

Having installed the components you should mark with the cursor Internet Protocol (TCP/IP) and click Properties. A window appears, in which Obtain an IP address automatically and Use the following DNS server addresses: Preferred DNS server: 217.195.65.9; Alternate DNS server: 217.195.66.253 should be marked. Then press OK. And once more OK.

4. Connecting the Internet via PeterStar

Now your PC is set and ready for connection to the Internet. For that start the created connection PeterStar, and to enter the Network fill in the fields Username and Password with data you were given at the registration, then press the button Dial. After dialing the number the PC establishes a connection with the server PeterStar, and at the right bottom of the task panel an additional icon appeàs in the form of two blinking monitors to inform you of the status of connection.

Should you have any question, you may contact our round-the-clock technical support service at phone 324-0277 at any time convenient for you, or e-mail a letter to the address:  support@peterstar.ru

Low-cost calls using Multicard - real economy! Low-cost Internet access using Multicard Where to buy Multicard